Pinoy Skateboardingby PRANAdize
← Home

🔧 Keep it rolling

Board care and setup

Set up a complete, tighten trucks, clean bearings after the rain, when to change wheels, grip and deck, with a maintenance log.

Setting up a complete

  • Grip tape: peel, lay from the nose, press out bubbles, file the edge with the side of a screwdriver and cut with a sharp blade.
  • Hardware: bolts go in from the top; trucks with the kingpins facing the middle of the board.
  • Wheels: tighten the axle nut until the wheel stops wobbling, then back it off a quarter turn so it spins freely.
  • Truck tightness: loose turns more, tight is more stable. Turn the kingpin nut a half turn at a time.
  • A skate tool (T-tool) does everything. Keep one in your bag.

After rain and puddles

  • Water rusts bearings and makes decks soft and heavy. Avoid wet skating in the rainy season, or keep an old board for it.
  • If your board gets wet: dry it with a cloth, stand it on its tail in the shade (not the sun), and spin the wheels so the bearings dry.
  • Clean bearings: remove the shields, soak in isopropyl alcohol, dry fully, then add one or two drops of skate bearing lubricant.

When to replace

  • Deck: when it loses its pop, chips deeply, cracks or turns soft and soggy.
  • Wheels: flat spots, cones or cracks. Rotate them every few weeks so they wear evenly.
  • Bearings: noisy or slow after cleaning.
  • Bushings: cracked or squashed; cheap to replace and change how the board turns.
  • Grip: smooth, worn patches where your feet go.

Maintenance log

  • Check bolts and axle nutsEvery 7 days · never loggedDue
  • Clean bearingsEvery 45 days · never loggedDue
  • Rotate wheelsEvery 21 days · never loggedDue
  • Check bushingsEvery 60 days · never loggedDue
  • Clean grip tape (eraser or grip gum)Every 30 days · never loggedDue
  • Inspect deck for cracks and razor tailEvery 14 days · never loggedDue